Garage Door Parts Tubular Shaft

• Customization: Available
• After-sales Service: Free
• Warranty: 2 Years
• Model NO.: TS001
• Material: Does Not Apply
• Thickness: Does Not Apply
• Opening Style: Does Not Apply
• Opening Type: Does Not Apply
• Motor Shaft: Does Not Apply
• Power: Does Not Apply
• Output Torque: Does Not Apply
• Door Panel Pattern: Does Not Apply
• Color: Walnut
• Surface Finishing: Finished
• Transport Package: Plastic Package
• Specification: 2mm/3mm
• Trademark: Dooren
• Origin: China
• HS Code: 7308900000
• Production Capacity: No Limit

Product Description

Garage Door Tubular Shaft
TUBULAR SHAFT WITH KEYWAY

galvanized

outside diam,25.4m

thickness of wall,2mm/3mm

L=5.85mm

1"bore with 1/4"keyway

for use to connect with garage door bars

standard packing

This product is used with good materials

The controller and the paired remote controller use millions of learning code encoding chips, with extremely low recoding rate and safer use.
This product has been paired with the remote controller and the controller before leaving the factory. There is no need to pair it again before use. If you need to increase or decrease the remote control, you can do the following steps to perform the pairing.
1,Press the stop button on the remote control first to stop the motor.
2,Press the code key on the controller to let go, the red light of the power indicator goes out, and then press any key on the remote control, the red light of the power indicator flashes three times, indicating that the code is successfully coded
Clear code (clear all remote controllers paired with the controller and follow the clear code steps), long press the code button on the controller to not let go. The power indicator red light flashes three times from on to off to indicate that the code is successfully cleared. (All remote controls previously paired with the controller have been cleared)
When you need to change the forward and reverse direction of the motor, please press and hold the remote control lock key for about 6 seconds, the controller power indicator flashes red three times, and the motor forward and reverse setting is successful. Lock key). Go back to the previous step and do the same.